Page 3 of 4

Re: Lampje blijft branden?? ATR

Posted: Tue Feb 07, 2012 1:26 pm
by Jo&
12 euro voor het uitlezen is toch netjes lijkt me!

Re: Lampje blijft branden?? ATR

Posted: Tue Feb 07, 2012 2:23 pm
by Machiel.
Dat vind ik altijd zo irritant allerlei autobedrijven/dealers geven de prijzen ex btw... Denk je dat bijvoorbeeld 100euro een redelijk bedrag is voor iets, wil je betalen kost het alsnog 119eu. Prijzen ex btw vertellen, zou verboden moeten worden :mrgreen:

Re: Lampje blijft branden?? ATR

Posted: Tue Feb 07, 2012 6:35 pm
by Gaskleppie
ATR is obd2b.

Dit is wat ik zo even snel vond:
http://www.engine-light-help.com/honda- ... light.html

oftewel:


Manufacturer Specific Codes

P1106 BARO Circuit Range/Performance Malfunction

P1107 BARO Circuit Low Input

P1108 BARO Circuit High Input

P1121 Throttle Position Lower Than Expected

P1122 Throttle Position Higher Than Expected

P1128 MAP Lower Than Expected

P1129 MAP Higher Than Expected

P1162 HO2S11 Circuit Fault (Bank 1 Sensor 1)

P1163 HO2S11 Slow Response (Bank 1 Sensor 1)

P1164 HO2S11 Circuit Fault (Bank 1 Sensor 1)

P1165 HO2S11 Slow Response(Bank 1 Sensor 1)

P1166 HO2S11 Heater Circuit Fault (Bank 1 Sensor 1)

P1167 HO2S11 Heater Circuit (VS+) Fault (Bank 1 Sensor 1)

P1168 HO2S11 Label Circuit Low Voltage Fault (Bank 1 Sensor 1)

P1169 HO2S11 Label Circuit High Voltage Fault (Bank 1 Sensor 1)

P1201 Cylinder 1 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0301

P1202 Cylinder 2 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0302

P1203 Cylinder 3 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0303

P1204 Cylinder 4 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0304

P1205 Cylinder 5 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0305

P1206 Cylinder 6 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0306

P1241 Throttle Vent Control Motor Circuit 1 Malfunction

P1242 Throttle Vent Control Motor Circuit 2 Malfunction

P1243 Throttle Position Insufficient

P1244 Closed Throttle Position Insufficient

P1246 Accelerator Position Sensor 1 Circuit Malfunction

P1247 Accelerator Position Sensor 2 Circuit Malfunction

P1248 Accelerator Position Sensors 1 & 2 Improper Correlation

P1253 VTEC System Circuit Fault

P1259 VTEC System Malfunction, Rear Bank (Bank 1)

P1279 VTEC System Malfunction, Front Bank (Bank 2)

P1297 ELD Circuit Low Input

P1298 Electrical Load Detector Circuit High Voltage

P1300 Random Misfire

P1301 Cylinder 1 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0301

P1302 Cylinder 2 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0302

P1303 Cylinder 3 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0303

P1304 Cylinder 4 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0304

P1305 Cylinder 5 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0305

P1306 Cylinder 6 Misfire - Compare possible causes/symptoms for this Honda check engine light code to the Generic OBD II code P0306

P1316 Spark Plug Voltage Detection Circuit Malfunction, Front Bank

P1317 Spark Plug Voltage Detection Circuit Malfunction, Rear Bank

P1318 Spark Plug Voltage Detection Module Reset Circuit Malfunction, Front Bank

P1319 Spark Plug Voltage Detection Module Reset Circuit Malfunction, Rear Bank

P1324 Knock Sensor Power Source Circuit Low Voltage

P1336 CKP Sensor B Range/Performance

P1337 CKP Sensor B Low Input

P1359 CKP/TDC Sensor Circuit Connector Disconnection

P1361 TDC Sensor Intermittent Interruption

P1362 TDC 1 Sensor No Signal

P1366 TDC 2 Sensor Intermittent

P1367 TDC 2 Sensor No Signal

P1381 CYP Sensor A Intermittent Interruption

P1382 CYP Sensor A No Signal

P1386 CYP Sensor B Intermittent Interruption

P1387 CYP Sensor B No Signal

P1456 Evaporative Emission Control System Leak Detected (Fuel Tank System)

P1457 Evaporative Emission Control System Leak Detected (Control Canister System)

P1459 EVAP Purge Flow Switch Malfunction

P1491 EGR Valve Lift Insufficient Detected

P1498 EGR Valve Lift Sensor High Voltage

P1508 IAC Valve Circuit Failure

P1519 IAC Valve Circuit Failure

P1607 ECM Internal Circuit Failure A

P1608 ECM Internal Circuit Failure B

P1655 TMA or TMB Signal Line Fault

P1656 Automatic Transmission System Malfunction

P1660 A/T FI Data Line Failure

P1671 A/T FI Data Line No Signal

P1672 A/T FI Data Line Failure

P1676 Traction Control System FI Data Line No Signal

P1677 Traction Control System FI Data Line Failure

P1678 FPTDR Signal Line Failure

P1681 A/T FI Signal A Low Input

P1682 A/T FI Signal A High Input

P1686 A/T FI Signal B Low Input

P1687 A/T FI Signal B High Input

P1690 Traction Control System STB Line Failure

P1696 Traction Control Fuel Cut Signal Low Input

P1697 Traction Control Fuel Cut Signal High Input

P1705 TCM A/T Gear Position Switch Circuit Shorted

P1706 TCM A/T Gear Position Switch Circuit Open

P1753 TCM A/T Lockup Solenoid Valve "A" Fault

P1758 TCM A/T Lockup Solenoid Valve "B" Fault

P1790 TCM A/T TP Sensor Circuit Fault

P1791 TCM A/T Vehicle Speed Sensor Circuit Fault

P1753 TCM A/T ECT Sensor Circuit Fault

P1709, P1738, P1739, P1768, P1773, P1788, P1793 & P1795 Automatic Transmission System Malfunction

Please verify the Honda check engine light code descriptions and testing procedures from our site, with an appropriate manual. Due to the amount of free content we provide, we cannot guarantee the accuracy of all information. We bend over backwards to make this information as accurate as possible, but sometimes we can make mistakes. Don't tell anyone though!

Re: Re:

Posted: Tue Feb 07, 2012 10:23 pm
by DC2
Keung wrote:Lijkt vaak erger dan het werkelijke is.
Er is een storingscode opgeslagen en dit vertaald zich in een gele controlelampje.
Als de lambdasensor echt defect is zul je dit merken aan het motorvermogen. Vaak is de voorverwarmingselement in de lamdasensor stuk. Dit is alleen nodig tijdens de opwarmfase van de motor.

Hier nog een DIY om je storingslampje uit te lezen.
http://www.honda-tech.com/showthread.php?t=1901557


Deze link heb ik over het hoofd gezien. Hierin wordt het knipperen van het lampje genoemd. Alleen geldt dit voor obd1.

@Frank, bedankt! Is er een apparaatje om zelf aan te schaffen, voor het uitlezen? Op Honda-Tech wordt gesproken over een zgn. "scantool".

Re: Lampje blijft branden?? ATR

Posted: Tue Feb 07, 2012 10:34 pm
by CTR-Asch
Die zijn er genoeg. Kijk maar eens op marktplaats. Eenvoudige scanapparatuur begint bij 70 -80 eu.

Re: Lampje blijft branden?? ATR

Posted: Tue Feb 07, 2012 10:57 pm
by DC2
Asch600RR wrote:Die zijn er genoeg. Kijk maar eens op marktplaats. Eenvoudige scanapparatuur begint bij 70 -80 eu.


En deze bijv.? http://link.marktplaats.nl/1001445782; ziet er vrij simpel uit..

Re: Lampje blijft branden?? ATR

Posted: Wed Feb 08, 2012 5:19 am
by slED9e
Dc2 zoals in jou ht link werkt gewoon ook bij atr.elm Bluetooth scantool ook

Re: Lampje blijft branden?? ATR

Posted: Wed Feb 08, 2012 6:46 am
by slED9e
7.5 a zekering voor klokje eruit 10 sec. Is Ecu reset

Re: Lampje blijft branden?? ATR

Posted: Thu Feb 09, 2012 8:34 pm
by rich1986
Deze link heb ik over het hoofd gezien. Hierin wordt het knipperen van het lampje genoemd. Alleen geldt dit voor obd1.



Hoeft niet alleen voor obd1 te zijn. Mijn prelude is obd2a en heeft een blauw stekkertje onder de radio verstopt zitten waarmee ik hetzelfde truukje kon doen. Mss zit er bij de accord type r ook wel ergens zo'n stekkertje

Re: Lampje blijft branden?? ATR

Posted: Thu Feb 09, 2012 8:40 pm
by DC2
slED9e wrote:7.5 a zekering voor klokje eruit 10 sec. Is Ecu reset


Is dit een alternatief voor + en - polen loskoppelen voor enkele minuten?

Re: Lampje blijft branden?? ATR

Posted: Fri Feb 10, 2012 8:09 am
by slED9e
Yep ..

Re: Lampje blijft branden?? ATR

Posted: Sat Feb 18, 2012 10:08 pm
by DC2
ECU gereset. Gestart, lampje uit, tijdens de eerste rit begon die opeens te knipperen om vervolgens weer uit te gaan. Tweede rit: lampje begon te knipperen direct na starten en bleef weer aan. Dus eigenlijk helaas weer terug bij af.

Re: Lampje blijft branden?? ATR

Posted: Sun Feb 19, 2012 6:26 pm
by Gaskleppie
Tja, zonder codes kunnen we je niet helpen.

Re: Lampje blijft branden?? ATR

Posted: Thu Feb 23, 2012 2:44 pm
by DC2
Gaskleppie wrote:Tja, zonder codes kunnen we je niet helpen.


Ik heb een scantool besteld. Heb er zin in om het uitlezen in ieder geval zelf te doen.

Waar zit de ecu van de ATR? In de voetenruimte van de passagier? Bodem of zijkant rechts?

Re: Lampje blijft branden?? ATR

Posted: Thu Feb 23, 2012 7:38 pm
by slED9e
Passagiersruimte, middenconsole waar plastic naar boven afbuigt

Re: Lampje blijft branden?? ATR

Posted: Thu Feb 23, 2012 7:59 pm
by donkeykong
je kon ook gewoon een ijzerdraadje gebruiken, dan knippert je dashboard lampje :)

Re: Lampje blijft branden?? ATR

Posted: Tue Mar 13, 2012 3:06 pm
by Bouli
Ik krijg nu spontaan een solid cell, zonder knippercodes (heb hem al uitgelezen, met verschillende soorten draadjes)

Maar auto start wel gewoon, toch massa of ECU probleem ?

Re: Lampje blijft branden?? ATR

Posted: Tue Mar 13, 2012 6:47 pm
by Gaskleppie
Zit het draadje er nog in? Dan heb je idd een solid cel

Re: Lampje blijft branden?? ATR

Posted: Tue Mar 13, 2012 7:45 pm
by Bouli
Welk draadje?

Re: Lampje blijft branden?? ATR

Posted: Tue Mar 13, 2012 8:58 pm
by slED9e
:toost: een van die verschillende
als auto het gewoon doet voor de rest